Differences

This shows you the differences between two versions of the page.

--- filaments:pa [2025/01/28 15:43] – [Disadvantages] megacookiez
+++ filaments:pa [2025/01/28 15:49] (current) – [Variants] megacookiez
@@ Line 14: / Line 14: @@
 ==== Variants ====
-Does the guidance on [[filaments:additives|additives]] apply?
+Standard guidance on [[filaments:additives|additives]] applies.
-==== Annealing ====
-Delete if it doesn't need annealing?
 ==== Baseline Printing Recommendations ====
@@ Line 30: / Line 27: @@
 ==== Other notes ====
-PA is really tricky.
+PA requires extensive preparation of the build plate so it will not warp. Certain glues that are not PVA family based are recommended.
+Most PA filaments will contain an additive like glass fibers with a typical concentration of 30% or carbon fibers with an unknown percentage of concentration.